- Home
- Parts by Type
- Parts by Bike
-
Installation Instructions and Videos
-
V-Strom Parts Instructions
>
- Mirror Extender Instructions
- Fork Brace Instructions
- DL650, DL100, DL1050 Footpeg and Control Lowering Instructions
- DL650, DL1000, and DL1050 Gear Shift Relocation Instructions
- DL800 Foot Peg and Control Lowering Kit
- Bolt-on Kickstand Foot Instructions
- Raising and Lowering Links >
- Shelves and GPS Mounts >
- DL1000 Rear Wheel Spacer Instructions
- Vee2 Saddlebag Guard
- Fender Riser 2014+ DL1000
- 2012+ DL650Fender Risers
- Retrieving Missing Parts from the Cowling
- Auxiliary Lighting >
- DL800 GIVI Crash Bars
- General Electrical and Lighting >
- Kawasaki Versys X300 >
- Yamaha Parts Instructions >
-
V-Strom Parts Instructions
>
- Shorter/Taller Riders
- Favorite Projects
- Adventure Motorcycling Links
- Frequently Asked Questions
- Contact Us
- Photos
- Specials and Promotions
DL1050 Light Bar
Remove the four plastic pins holding the flat dressing plate under the chin.
Find the bar running across from side to side.
Insert the u bolts on both sides of the bar. The U-bolt on the riders right side (Left side when viewed from the front) has to be installed as below. The bottom of the picture would be the back of the bike. The U-bolt should be held horizontal and angled in toward the center of the bike.
Find the bar running across from side to side.
Insert the u bolts on both sides of the bar. The U-bolt on the riders right side (Left side when viewed from the front) has to be installed as below. The bottom of the picture would be the back of the bike. The U-bolt should be held horizontal and angled in toward the center of the bike.
Install the spacer blocks on the u-bolts. These are the 1" tall pieces rounded on both ends with slots.
Place bar on U-bolts.under spacers
Install Nylock Nuts
Reinstall dressing plate (or not, doesn't matter).